ANSI 400kN Triangular Pipeline Fixing Bracket / Spring Hanger Supports

Product Specification

Products  decription:

Triangular Support Bracket For Natural Gas Pipeline Pipeline Fixing Bracket

Triangular Support Bracket For Natural Gas Pipeline Pipeline Fixing Bracket

Pipe support refers to a structural member used to support pipeline laying on the ground. Divided into fixed brackets, sliding brackets, guide brackets, rolling brackets, etc. Pipe supports are used wherever pipes are laid, and are also called pipe supports, pipe parts, etc. As the supporting structure of the pipeline, the pipe frame is divided into fixed and movable according to the operation performance and layout requirements of the pipeline. The place where the fixed point is set becomes the fixed bracket. This kind of pipeline and the pipeline bracket cannot have relative displacement. Moreover, the deformation of the fixed pipe frame after being stressed should be small compared with the deformation value of the pipeline compensator, because the pipe frame must have enough The stiffness. The place where the intermediate support is set adopts the movable pipe rack, and the relative displacement between the pipe and the pipe rack is allowed, and the thermal deformation of the pipe is not restricted

The friction pair of the sliding pipe support device adopts a new composite PTFE sliding sheet and mirror stainless steel material. Compared with the steel friction pair, the steel and PTFE plate friction pair, and the bearing of the rolling friction pair, it has the following characteristics:
1. Low friction coefficient: dry sliding friction coefficient is below 0.1;
2. Good self-lubrication: no need to inject oil or lubricant between friction pairs, reducing maintenance workload;
3. Strong adaptability: No matter there is oil and no oil, water and no water, dust embedding or mud and sand, it can work with a very low friction coefficient, and the performance is stable and reliable;
4. Wear resistance: under normal conditions, the service life is more than 25 years.
2. Scope of application
1. The supports are divided into three types: horizontal pipe type, vertical pipe type and elbow pipe type according to the pipeline arrangement;
2. The supports are divided into three categories: hot pipes, normal temperature pipes and cold pipes according to the operating temperature;
3. The support is suitable for pipe outer diameter Dn25～Dn4000mm, hot temperature 0℃～560℃, cold temperature 0℃～-200℃, axial displacement 0～400mm, radial displacement 0～200mm, load range 0～3350KN.
Three, design selection
1. The sliding bearing product series are divided into three categories according to the pipeline form: horizontal pipe sliding bearing, elbow pipe sliding bearing, and vertical pipe sliding bearing. Horizontal pipeline sliding supports are divided into three levels: T-shaped (T-shaped), square-shaped (F-shaped), and saddle-shaped (M-shaped) according to pipe diameter and load. Each level is divided into welding type (H) according to the installation form. And pipe clamp type (G) two kinds. According to the pipe diameter and load, the elbow pipe sliding support is divided into three levels: round pipe type (RP type), elbow type (RP type), and square pipe type (RX type). Riser type sliding bearings are divided into riser T-shaped (LT type) and riser square (LF type) according to pipe diameter and load. Each category has four categories: axial sliding (Z), two-way sliding (S), guided sliding (D), and double guided sliding (SD)