Corrugated Flexo Printer Slotter Machine

Product Specification

                                                                    Corrugated Flexo Printer Slotter Machine

                                                                                            Model: HS 1628 EXTRA

Feeding Unit

1.Electric controlling the clutch of the machine platform and installed alarms in order to assure the safe of the operator while the bell rings constantly during marching.
2.Drive shaft is equipped the clutch in order to avoid the wrong operation damaging the machine(if the machine is not locked ,the main motor could not revolve)
3.Pneumatic type interlocking device.
4.Main motor startup protection device.
2.Lead edge feeding paper system(domestic)
1.Lead edge feeding paper system can decrease the clogging when feeding paper.
2.Wind absorbing auxiliary feeding paper , so the bending paper can feed in smoothly, the quantity of the wind could adjust according to the paperboard , it can ensure the
3.vacuum adsorptive power , so the feeding paper is much precise.
4.Front and back baffle adopt manual adjustment , the left and right baffle adopts electric adjustment.
5.The feeding paper wheel adopts Polyurethane , strong friction and long using life.
6.The machine is suitable three layer and five layer corrugated paperboard ,including the E corrugated paperboard.
7.Feeding paper counter , set and display the production.
3.Absorb dust device
It is equipped the clear dust device (upper wind absorbing , clear dust brush) , it can clear the dust and impurity on the paperboard and increase the printing quality.
4.Feeding paper roller
1.Seamless steel tube is packed with the wear resisting rubber and has gone through the dynamic revise
2.The under feeding paper is chromed
3.The gap between feeding paper rollers adopt manual adjustment , the adjusting range is 0-11mm
4.The operating control switch

Printing Unit

1.Printing roller
1.It adopt steel material , the surface adopts grinding and is hard chromed.
2.It has gone through dynamic revise with steady revolving.
3.It adopt ratchet wheel device to fix the printing plate roller.
4.Whole printing plate ditch , it is suitable the 9mm hang version bar.
5.Load and unload the printing plate , the step switch control the positive and negative revolving.
6.The gap between the printing roller adopts manual adjustment , the range is 0-11mm
2. Printing press roller
1.Surface of the steel tube adopt grinding and is chromed.
2.The roller has gone through the dynamic revise with steady revolving.
3.The printing press roller adopt manual adjustment , the adjusting range is 0-11mm.
4.Feeding paper roller gap adopts manual adjustment , the range is 0-11mm.
3. The metal anilox roller ( the customer choose the roller mesh number )
1.Surface of the steel tube adopt advanced hard chromium plating craft , it is hard , smooth and wear resisting.
2.Lattice point consistent , linking effect is uniformity
3.It can prolong the printing plate and rubber roller life.
4.The gap of the anilox roller adopt manual adjustment.
4. Rubber roller
Surface of the steel tube is packed with wear resisting rubber.
The rubber roller adopt medium and high level grinding , the ink effect is very good.
5. Upper and under feeding paper roller
1.The upper roller , the external diameter is Ф85mm , the material is seamless steel tub, it is equipped with four feeding paper wheel
2.The under roller , the external diameter is Ф148mm , surface of the roller adopts grinding and is chromed.
3.The gap of feeding paper roller adopt manual adjustment , the range is 0-11mm.
6. The printing phase adjusting device.
1.The planet type gear structure.
2.The printing phase adopt PLC , touching screen and electric numerical 360 degrees
3.adjust (it can adjust both revolving and stopping)
4.The lateral adjustment range is 20mm with manual adjustment.
5.The printing plate adopt inverter adjusting the phase . It is quick to zero and adjust the printing plate, the adjusting printing plate precision is high.