FEP film

USEAGE

It is used for making the electric iron bottom board ;felting the tie-in of F4 wax cloth zone , conveyer belt;the stickup layer in the middle of the F4 with copper board and jointing the F4 board after it is unfreezed.

Mould Release

Electric window

Dielectric

It is used for making the high-temperature basic material of the sticky tape and capacitor.

Protective materials of freezing the biology

Nometal compensators use in the thermo electricity factory ect.

Against-burst electrical instruments

The surface protective materials

Lab cell bag,dish,Gas bag etc

Speciality

Good plaster and thermo sealing with F4 ect.

It won't be wet with any other things when it is under the melting point.when it is above the melting point,it can have a good plaster with F4,metal even itself.

Bear high and low temperature.

It can be used at the temperature of -200^oC through 200^oC.

Nonsticky .Against water and oil

Water tangency angle=114

Electric dependability,high insulating

Dielectric constant will always be 2.1 no matter when it is at the high or low temperature (60Hz-60MNz).Even if its surface is hurt because of fire,it wont have conductive rail

Volume resistivity>10¹⁸ohm

Bear electric arc >165 seconds ,it won't creepage

It has a good penetrability for the ultraviolet radiation and the visible light,and it has the lower refraction thanany other plastic .

lay-flat film(mm)

thickness (mm)

200-250

0.02-0.015

250-280

0.03-0.04

250-300

Company Details

• 

  Business Type:

  Manufacturer,Distributor/Wholesaler,Exporter,TradingCompany,Seller 

• 

  Year Established:

  2004 

• 

  Total Annual:

  $1,000,000-$5,000,000

• 

  Employee Number:

  >less than 50 

• 

  Ecer Certification：

  Active Member 

Everyday new companies open, and companies die. Most died companies was caused by the founders,including his bad management,his short dream and his attitude to the customers... Everyday new companies open, and companies die. Most died companies was caused by the founders,including his bad management,his short dream and his attitude to the customers...

+ Read More