Single - Chip Control Horizontal Vertical Flammability Test Equipment Corrosion

Product Specification

Single - Chip Control Horizontal Vertical Flammability Test Equipment Corrosion Resistant​

The tests are to comply with UL1581-2001 section 1060) vertical burning and FT1 test), 1061

(cable burning test), 1080 (VW-1 burning test), 1090 (electric appliance horizontal burning test),

1100 (Horizontal sample / FT2 combustion test) requirements.
 

This experiment mainly consists of the following major components:
 

1, the test box:
 

A, the test box made of 304 stainless steel, with a beautiful appearance, rust and corrosion

characteristics.
 

B, the top of the box is equipped with ventilation and exhaust system, after the test can be

exhausted to the outdoor exhaust (such as environmental requirements, can do another

environmental treatment system)
 

C, the front of the box has a tempered glass observation door, easy to observe the test situation
 

D, the operation panel is located on the right side of the observation door, easy to operate.
 

E, test box specifications: 180CMX130CMX180CM, volume: 4.2M3;
 

2, the control system:
 

A, the control system using single-chip control, push-button selection switch to select a different

test mode to meet the needs of the standard, test time, number of tests,
 

Time, etc. can be set to keep burning and record. Delayed combustion timing using

photosensitive automatic control, according to test conditions automatically stop timing and

timing;
 

B, equipped with high-precision flame control system, can automatically and accurately record

the burning time after stopping the fire, without manual recording, to reduce test error.
 

C, equipped with temperature measurement system, can accurately control and debug the test

required for the test temperature.
 

1) Thermal sensors (copper conduits and thermocouples) - The conduit structure shall be

electrolytically copper of very high conductivity. 1.75 grams of catheter flame is 20mm,
 

The flame of the 10-gram catheter is 125 mm.
 

2) K-type thermocouple, with 0.5mm diameter stainless steel tube jacket.
 

3) intelligent temperature control table and K-type thermocouple to match. The reading can reach

more than 1000 ℃.
 

3, the test device and test fixture:
 

A, the main fixture: the sample holder and the burning torch
 

B, sample support: made of 304 stainless steel, sub-level bracket and vertical bracket
 

C, combustion burner: to meet the requirements of ASTM D 5025-99, the standard power:

vertical spray for the 500W, horizontal spray for the 225W,
 

Ejector diameter: 9.5 ± 0.5mm, nozzle from the air inlet height of 102mm, torch angle: the level of

90 degrees, vertical 20 degrees
 

4, gas and gas flow control system:
 

A, gas: methane, purity 98% (to be certified by the supplier certificate), calorific value 998BTU

(British thermal units) / cubic feet.
 

37.1 MJ per cubic meter. (Own)
 

B, gas flow control system:
 

1) mainly include: flow meters, pressure gauges, pressure reducing valve
 

2) Flowmeter: In accordance with D3195 standard calibration. Equipped with a flow meter with a

precision of at least 2%. Flow range: 1000ml / min.
 

3) Gas pressure reducing valve: 1, the gas flow can be adjusted to 10 pounds per cubic inch.