ECG Medical Equipment Hospital Patient Simulator With Respiratory Wave

Product Specification

ECG Medical Equipment Hospital Patient Simulator With Respiratory Wave

ECG simulator 10 leads ECG machine simulator with Respiratory wave patient monitor simulator build-in battery

Specification of medical simulator:

The simulator can generate waveform as below, the first code represent waveform as below
1.Normal ECG waveform
2.Plus-minus triangular waveform
3.Heart rate uneven analog triangular waveform
4.Square wave, used the square wave to measure scan speed
5.Sinusoidal wave, measure amplitude-frequency characteristic
6.Respiratory wave
7.Calibration waveform 1MV
8.Setting signal range

Dimension: 15x10x3cm
N.W.: 0.35kg


Note:
1.The simulator will automatically generate Normal ECG waveform when connect to power
2.The LED display will be off automatically if without operation after 5 seconds, press any key will be returned to display
Key Description:

There are 4 keys, followed by selection keys, increase key, reducing key, the Enter key, in addition to a set of key combinations

Select Key:

This key is used to select the parameter you want to change; there are 4 LED tubes to display the four codes represent what is displayed,
The 1st LED representative waveform code, LED 2-4 representatives the parameter (2 is the value of one hundred, 3 representatives of ten, 4 representatives of bits)

Operation of each waveform and adjustable range

1.Normal ECG waveform
* Heart rate setting range: 10-200bpm (Initial value: 60 bpm)
* Signal amplitude is fixed

2. Plus-minus triangular waveform
* Frequency range: 10-300bpm (Initial value: 75 bpm)
* Amplitude range: 0.1-4Mv (10:0.1mV, 400:4mV)
* 2 modes, Mode 1: Positive waveform; mode II: negative waveform; Use combinations key to choose.

3. Heart rate uneven analog triangular waveform
* Frequency range: 20-250bpm; (Initial value: 80 bpm)
* Amplitude range:0.1-4Mv (10:0.1mV, 400:4mV)
* 2 modes, Mode 1:big waveform in upside, Mode 2: big waveform in downside, Use combinations key to choose.

4. Square wave
* Frequency range: 0.1Hz-10Hz (10:0.1Hz, 100:10Hz); (Initial value: 1 Hz )
* Amplitude range: 0.1-4Mv (10:0.1mV, 400: 4mV);

5. Sinusoidal wave
* Frequency range: 1-100Hz (Initial value: 10 Hz)
* Amplitude range: 0.1-4Mv (10:0.1mV, 400:4mV)
* Can be superimposed on the DC component of the waveform, range is 0.1mV-3mV (10:0.1mV, 400: 4mV);
* Use the combinations key, select the parameter need to be changed, model 1: Frequency; model 2: superimposed DC component(10:0.1mV ,400:4mV);

6. Respiratory wave:
* Frequency rang: 1-100times/minutes. (Initial value: 10 bpm);
* Note: ignore the ECG signal at this moment

7. Calibration waveform 1MV 100US
* Frequency range: 60bpm;

8. Signal range setting
* Amplitude range: 0.1mV-4mV (10: 0.1mV, 400: 4mV) ; (Initial value: 100)
* Note: this amplitude setting will affect all waveforms except ECG waveform

Feature: