Product Specification

OSRAM halogen lamp beads 64602 12V50W

optical instrument halogen bulb pin rice bubble equipment bulb

►Quick Detail:

Osram halogen bulb 64602 12V50W optical instrument halogen bulb 

It is indeed important to replace the position of the optical instrument lamp. Regardless, it should be adjusted to be exactly up, down, left, right, and whether the lamp holder of the bulb is at the same height as the reflector, and the direction of the light should not be skewed. Be sure to adjust the position of the replaced bulb properly, otherwise imbalance and deviation may occur.
Before replacing the light bulb, please wipe the grating with ethanol. Before replacing the light bulb, some preparation work should be done: place a neatly cut filter paper in the position of the sample cell, and it should be closely attached to the position where the transmitted light in the light path passes through to the photovoltaic cell, so that you can see the intensity of the light. Then adjust the whole wavelength position and record the color of light at each specific position, especially the wavelength values of positive red, positive blue, positive yellow, positive green and positive purple. The purpose of observing and recording these values is to restore them to their original state after replacing the light bulb in the future, which indicates that there must be no problem with the replacement.

► Attention to the use environment of light bulb replacement or optical instruments:

▪ Temperature control: To avoid lens cracking and detachment caused by thermal expansion and contraction, it is recommended to maintain the temperature of the microscope room at 20-24 ℃.
▪ Dust prevention: Dust falling on the surface of optical components not only affects the passage of light, but also generates large stains after being magnified by the optical system, which affects observation. Dust and sand particles falling into the mechanical parts can also increase wear and tear, posing significant hazards. Therefore, the microscope room should be kept clean, and a dust cover should be used to cover the microscope when not in use to prevent dust from falling off.
Moisture proof: When the air is too humid, optical lenses are prone to mold and fogging; Mechanical parts are prone to rusting when exposed to moisture. Normally, the microscope room should maintain a humidity of below 65%, and dehumidifiers should be installed indoors in humid areas.

►Key features:

► Company situation:

The company has been professionally operating various brands of original medical monitoring instruments since 2015. The company has many professional senior engineers and has sufficient ability to undertake various medical equipment maintenance work. Covering motherboards, sensors, probes, modules, connectors, shells, etc. for various medical monitoring equipment.

►About delivery:

We default to express delivery by DHL,Fedex, We will contact you as soon as possible when sending express delivery. If you have any questions after receiving the express delivery, please feel free to contact us at any time.